Siemens SCALANCE XM-400 Configuration Manual page 847

● Incoming and/or outgoing TCP segments of hosts of a specific subnet are forwarded.
● Incoming and/or outgoing TCP segments are forwarded to specific ports.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the access control list is not used for this.
Requirement
You are in the ACL standard configuration mode.
The command prompt is as follows:
cli(config-std-nacl)#
Syntax
Call up the command with the following parameters:
permit tcp {any | host <src-ip-address> | <src-ip-address> <src-mask>} [{ gt <src-
port-number(1-65535)> | lt <src-port-number(1-65535)> | eq <src-port-number(1-65535)>
| range <src-port-number (1-65535)> <src-port-number (1-65535)>}] [{any | host <dest-
ip-address> | <dest-ip-address> <dest-mask>}] [{ gt <port-number(1-65535)> | lt
<port-number(1-65535)> | eq <port-number(1-65535)> | range <port-number (1-65535)>
<port-number (1-65535)>}] [dscp<value(0-63)>] [{ack | rst}]
The parameters have the following meaning:
Parameter
any
host
src-ip-address
src-ip-address
src-mask
src-port-number
port-number
gt
lt
eq
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Forwards all incoming TCP segments.
Keyword for a an individual IPv4 ad-
dress
Source IPv4 address
Network source address
Corresponding subnet mask
Port number
Keyword for port numbers higher than
the specified number (gt: greater than).
Keyword for port numbers lower than
the specified number (lt: less than).
Keyword for a specific port number
(eq:equal).
Security and authentication
11.4 IP access control list
Range of values / note
-
-
Enter a valid IPv4 address.
Enter a valid combination of IPv4
address and subnet mask.
1 ... 65535
-
-
-
847