Show Ip Static Route; Show Ip Gateway - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Parameter
rip
static
summary
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv4 routing table is displayed.
7.1.1.2

show ip static route

Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.
7.1.1.3

show ip gateway

Description
This command shows the default gateway configured for the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
286
Description
Shows the RIP entries in the routing
table.
Shows the static routes in the table.
Shows a summary.
or
cli#
or
cli#
Range of values / note
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11