Permit Icmp - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

The IP access list has been configured.

Subnet mask for individual hosts

If you create the rule for a single system (one IP address), you will need to specify the

subnet mask "255,255,255,255". As an alternative, you can specify the keyword "host"

followed by the IP address.

Further notes

You delete an IP access control list with the

You display the configuration of the access control list with the

permit icmp

With this command, you configure an IP access control list for ICMP messages.

You have the following options:

● All incoming and/or outgoing ICMP messages are forwarded.

● Incoming and/or outgoing ICMP messages of a specific host are forwarded.

● Incoming and/or outgoing ICMP messages of hosts of a specific subnet are forwarded.

Processing order of the lists

The access control lists are processed on the interface in the order in which they were

The index number of the access control list is not used for this.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Keyword for the Differentiated Services

Value for the Differentiated Services

no ip access-list standard <acl-num>

Security and authentication

11.4 IP access control list

Range of values / note

show access-lists