Show Interfaces; Show Ip Interface; Show Interfaces ... Counters - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

The status and the configuration of the selected interfaces are displayed.

This command shows the counters of one, several or all interfaces.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show interfaces

[{<interface-type><interface-id>]|{vlan<vlan-id(1-4094)>}]counters

The parameters have the following meaning:

interface-type

interface-id

For information on identifiers of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

If you do not select any parameter from the parameter list, the entries are displayed for all

available counters.

The counters of the selected interfaces are displayed.

This command shows the configuration of one, several or all IPv4 interfaces.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Type or speed of the interface

Module no. and port no. of the interface

Keyword for a VLAN connection

Number of the addressed VLAN

Configuration

Range of values / note

Enter a valid interface.