Show Spanning-Tree Root - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree passive-listening-compatibility [interface [<interface-
type><interface-id>]]
The parameters have the following meaning:
Parameter
instance
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The setting for the "Enhanced Passive Listening Compatibility" function is displayed.
Further notes
You enable the "Enhanced Passive Listening Compatibility" function with the
passive-listening-compatibility
You disable the "Enhanced Passive Listening Compatibility" function with the
tree passive-listening-compatibility
6.3.1.11

show spanning-tree root

Description
This command shows the settings of the root bridge for the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show spanning-tree root
[{address|cost|forward-time|id|max-age|port|priority|detail}]
242
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
command.
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Range of values / note
-
Enter a valid interface
spanning-tree
no spanning-