Layer 3 functions
9.3 OSPFv3 (IPv6)
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
9.3.4.1
ipv6 ospf area
Description
With this command, you enable OSPFv3 on the interface. The interface is assigned to an
area.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● The router ID is configured.
● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf area <IPv4-Address>
The parameter has the following meaning:
Parameter
IPv4-Address
Result
The interface is assigned to an area.
602
Description
IPv4 address of the interface with which the
OSPFv3 protocol instance is connected.
command, you return to the
exit
command, you return to the
end
Range of values / note
specify the IP address in the
IPv4 address format.
x.x.x.x
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11