Dhcp Server; The "Show" Commands - Siemens SCALANCE XM-400 Configuration Manual

Network protocols

7.5 DHCP server

Requirement
● DHCPv6 Is activated.
● The DUID is of the type
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client-id interface {<interface-type> <interface-id>}
The parameters have the following meaning:
Parameters
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP interface is assigned.
Further notes
You enable the function DHCPv6 client with the
You configure the DUID with the
7.5 DHCP server
This section describes commands relevant for configuring the DHCP server.
Requirement
The connected devices are configured so that they obtain the IPv4 address from a DHCP
server.
7.5.1

The "show" commands

This section describes commands with which you display various settings.
346
or
llt ll
Description
Type or speed of the interface
Slot no. and port no. of the interface
ipv6 dhcp client-id type
Range of values / note
Enter a valid interface.
command.
ipv6 address dhcp
command.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11