Dot1X Guest-Vlan Reset - Siemens SCALANCE XM-400 Configuration Manual

Result
The ID of the guest VLAN has the value 1.
Further notes
You configure the guest VLAN ID with the
You display this setting and other information with the
11.7.3.5

dot1x guest-vlan reset

Description
This command removes MAC addresses from the guest VLAN. If you specify a MAC
address, only this MAC address is removed from the guest VLAN. If you use this command
without parameters, all MAC addresses are removed from the guest VLAN.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dot1x guest-vlan reset [mac <aa:aa:aa:aa:aa:aa>]
The parameter has the following meaning:
Parameter
mac
Result
The specified MAC address or all MAC addresses are no longer assigned to the guest
VLAN.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
11.7 Port-based Network Access Control (Dot1X)
dot1x guest-vlan vlan-id
Description
Keyword for the MAC address
MAC address to be removed from the
guest VLAN.
Security and authentication
command.
command.
show dot1x
Range of values / note
-
aa:aa:aa:aa:aa:aa
873