Commands In The Global Configuration Mode; Ipv6 Router Rip - Siemens SCALANCE XM-400 Configuration Manual

Result
The information is displayed.
9.7.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
9.7.2.1

ipv6 router rip

Description
With this command, you enable RIPng routing on the device change to the Router
configuration mode.
Note
This command is available only with layer 3 (IPv6).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipv6 router rip
Result
Routing with RIPng is enabled.
You are now in the RIPng router configuration mode.
The command prompt is as follows:
cli (config-ripng)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command to change to this mode.
configure terminal
or
end exit
Layer 3 functions
9.7 RIPng (IPv6)
command and are then in the
695