Router Pim; Ip Pim Static-Rp - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

router pim

With this command, you change to the PIM configuration mode.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call the command without parameter assignment:

You are now in the PIM configuration mode.

The command prompt is as follows:

cli(router-pim)#

Further notes

You enable PIM globally on the device with the

With this command, you configure the device as a static rendezvous point.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Call the command without parameters:

ip pim static-rp

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

ip pim routing

Layer 3 functions

9.10 PIM (IPv4)