7.5.1.1
show ip dhcp-server bindings
Description
This command shows the current assignments of IPv4 addresses of the DHCP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip dhcp-server bindings
Result
The information is displayed.
7.5.1.2
show ip dhcp-server pools
Description
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-24)]
The parameter has the following meaning:
Parameter
pool-id
If no parameters are specified, the settings for all address bands are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
or
cli#
Description
ID of the addressed IPv4 address
band
Range of values / note
1 ... 24
Network protocols
7.5 DHCP server
347