Lease-Time; Network - Siemens SCALANCE XM-400 Configuration Manual

7.5.3.1

lease-time

Description
With this command, you specify how long the assigned IPv4 address remains valid. When
half the period of validity has elapsed. the DHCP client can extend the period of the assigned
IPv4 address. When the entire time has elapsed, the DHCP client needs to request a new
IPv4 address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
lease-time <seconds (60-31536000)>
The parameter has the following meaning:
Parameter
seconds
Result
The time is configured.
Further notes
You display the setting with the
7.5.3.2

network

Description
With this command you configure the IPv4 address band from which the DHCP client
receives any IPv4 address.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Time until renewal of the assigned
IPv4 address in seconds
show ip dhcp-server pools
Network protocols
7.5 DHCP server
Range of values / note
60 ... 31536000
command.
353