Network structures
6.1 VLAN
6.1.3.6
no switchport acceptable-frame-type
Description
With this command, you reset the setting for the types of frames accepted by the interface to
the default value.
The default value is
The interface accepts tagged and untagged frames.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport acceptable-frame-type
Result
The setting is reset to the default value.
Further notes
You configure the setting with the
You can display the status of this function and other information with the
config
6.1.3.7
switchport access vlan
Description
With this command, you assign an VLAN to an interface and configure the port VLAN
identifier (PVID) for it.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
204
.
all
command.
switchport acceptable-frame-type
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
show vlan port