No Ip Igmp Explicit-Tracking - Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
Requirement
● You use IGMP version 3.
● You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
ip igmp explicit-tracking
Result
"Explicit Tracking" is enabled on the interface.
Further notes
You configure the IGMP version with the
You disable "Explicit Tracking" on an interface with the
command.
You display the setting and other information with the
command.
8.2.3.4

no ip igmp explicit-tracking

Description
With this command, you disable die function "Explicit Tracking" on an interface.
Requirement
● You use IGMP version 3.
● You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp explicit-tracking
444
command.
ip igmp version
no ip igmp explicit-tracking
show ip igmp global-config
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11