Show Pse Status; Commands In The Global Configuration Mode; Poe Pse Maximumpower - Siemens SCALANCE XM-400 Configuration Manual

3.5.1.2

show pse status

Description
This command shows the current settings of the PoE power supply of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show pse status [<integer>]
The parameter has the following meaning:
Parameter
integer
If you do not select any parameter, the entries are displayed for all available PSEs.
Result
The current settings of the PoE power supply of the device are displayed.
3.5.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.5.2.1

poe pse MaximumPower

Description
With this command you can set a value for the parameter "Maximum Power". This sets the
maximum power that a PSE provides to supply PoE devices.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Number of the PSE
configure terminal
or
end exit
Range of values / note
-
command to change to this mode.
command and are then in the
Configuration
3.5 PoE
129