Layer 3 functions
9.3 OSPFv3 (IPv6)
Syntax
Call the command without parameters:
show ipv6 ospf redundancy
Result
The OSPFv3 redundancy is shown.
9.3.1.10
show ipv6 ospf route
Description
This command shows the routes that were generated with OSPFv3.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ipv6 ospf route
Result
The routes are displayed.
9.3.1.11
show ipv6 ospf virtual-links
Description
This command shows an overview of the virtual connections of OSPFv3.
Note
This command is available only with layer 3.
574
or
cli#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11