Ipv6 Dhcp Relay Remote-Id Duid - Siemens SCALANCE XM-400 Configuration Manual

7.7.4.4

ipv6 dhcp relay remote-id duid

Description
With this command, you specify the DUID (DHCP Unique Identifier).
Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● In "
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay remote-id duid <duid-id string(299)>
The parameter has the following meaning:
Parameters
duid-id
Result
The DUID is specified.
Further notes
You enable the remote ID with the
You enable the DHCPv6 relay agent with the
You configure the interface as a router port with the
You configure the remote ID type with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
", is set.
remote-id type duid
Description
DHCP unique identifier
Range of values / note
Enter the DUID.
max. 299 characters
ipv6 dhcp relay remote-id.
ipv6 address dhcp relay
no switchport
ipv6 dhcp relay remote-id type
Network protocols
7.7 DHCPv6 Relay Agent (IPv6)
command.
command.
command.
command.
383