Show Ipv6 Traffic - Siemens SCALANCE XM-400 Configuration Manual

Result
The summary is displayed.
7.2.2.5

show ipv6 traffic

Description
This command shows the statistics for UDP and ICMPv6 for the corresponding interface.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 traffic [
] [hc]
The parameters have the following meaning:
Parameter
interface
vlan
vlan-id
interface-
type
interface-id
hc
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the statistics are displayed for all
available IP interfaces.
Result
The statistics are displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
interface { vlan <vlan-id> | <interface-type> <interface-id> }
Description
Keyword for the interface via which the statistics
are created.
VLAN
•
Interface
•
Keyword for a VLAN
Keyword for a VLAN connection
Type or speed of the interface
Module no. and port no. of the interface
Display of the High counters parameter
Network protocols
7.2 IPv6 protocol
Range of values / note
-
-
1 ... 4094
Enter a valid interface.
-
309