Vrrpv2 (Ipv4); The "Show" Commands; Show Vrrp - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

VRRPv2 (IPv4)

This section describes the commands relevant for working with routing with VRRP.

• The commands are only available with layer 3 and only in conjunction with VLAN

interfaces. Router ports are not supported

• Enable routing to be able to use VRRP.

• VRRP supports only IPv4. If you want to use IPv4 and IPv6, use VRRPv3

VRRP and DHCP server

If you want to operate a DHCP server on the devices of a VRRP group, the DHCP server

must be configured on the master router. Backup routers do not react to DHCP queries.

Make sure that the master router is statically configured and that after a failure, becomes the

master of the VRRP group again.

This section describes commands with which you display various settings.

This command shows the settings of a virtual router.

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

Call up the command with the following parameters:

show vrrp [interface vlan <vlan-id(1-4094)> <VrId(1-255)>]

[{brief|detail|statistics}]

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

Layer 3 functions

9.4 VRRPv2 (IPv4)