Commands In The Vrrp3 Router Configuration Mode; Interface - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Commands in the VRRP3 Router configuration mode

This section describes commands that you can call up in the VRRP3 Router configuration

In the Global configuration mode, enter the

● If you exit the VRRP3 Router configuration mode with the

the Global configuration mode.

● If you exit the VRRP3 Router configuration mode with the

Privileged EXEC mode.

With this command, you decide the interface for which you want to assign parameters in the

VRRP3 Router configuration mode.

There you can edit the settings for a VRRP3 interface. You select the VRRP3 interface with

the parameters of this command.

This command is available only with layer 3.

You are in the VRRP3 Router configuration mode.

The command prompt is as follows:

cli (config-vrrp-v3)#

Call up the command with the following parameters:

interface vlan <vlan-id(1-4094)>

The parameters have the following meaning:

For information on names of addresses and interfaces, refer to the section "Interface

identifiers and addresses (Page 42)".

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

router vrrp3

Keyword for a VLAN connection

Number of the addressed VLAN

Layer 3 functions

9.5 VRRPv3 (IPv4 / IPv6)

command to change to this mode.

command, you return to

command, you return to the

Range of values / note