Area Stub - Siemens SCALANCE XM-400 Configuration Manual

The parameters have the following meaning:
Parameter
area-id
no-summary
default-
information-
originate
Result
The area of the type NSSA is configured.
Further notes
You change the type of the area with the
9.2.3.7

area stub

Description
With this command, you configure areas of the type Stub.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
area <area-id> stub [ no-summary ]
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Area-ID
NSSA does not receive a summary
LSA.
Generating a standard route (LSA type
7) in the NSSA.
no area
Range of values / note
specify a valid ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
--
--
command.
Layer 3 functions
9.2 OSPFv2 (IPv4)
529