Set Dot1X Guest-Vlan Mac-Addr Count; Dot1X Mac-Auth - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.7 Port-based Network Access Control (Dot1X)
11.7.3.6

set dot1x guest-vlan mac-addr count

Description
With this command, you specify how many MAC addresses can be authenticated on the port
at the same time.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
set dot1x guest-vlan mac-addr count <num-of-addresses (1-100)>
The parameter has the following meaning:
Parameter
num-of-addresses
Result
The maximum number of devices for the port has been specified.
Further notes
You display this setting and other information with the
11.7.3.7

dot1x mac-auth

Description
With this command, you enable MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
874
Description
Maximum number of devices
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
1 ... 100
command.
show dot1x
Configuration Manual, 06/2016, C79000-G8976-C252-11