9.2.1.2
show ip ospf route
Description
This command shows the routes that were generated with OSPF.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip ospf route
Result
The routes are displayed.
9.2.1.3
show ip ospf - database summary
Description
This command shows a summary of the database.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip ospf
database
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
or
cli#
[area-id]
[{
database-summary|self-originate|adv-router <ip-address>
}]
Layer 3 functions
9.2 OSPFv2 (IPv4)
513