Commands In The Global Configuration Mode; Clear-All-Static-Unicast; Auto-Learn - Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.5 Port Access Control List Locked Ports
11.5.2

Commands in the Global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
11.5.2.1

clear-all-static-unicast

Description
With this command, you delete all static unicast MAC address entries from the MAC address
table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
clear-all-static-unicast
Result
The static unicast MAC address entries are deleted from the MAC address table.
11.5.2.2

auto-learn

Description
With this command, you change to the AUTOLEARN mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
856
command to change to this mode.
configure terminal
or
end exit
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command and are then in the