No Ip Nat Pool; Ip Nat Service - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.9 NAT (IPv4)

no ip nat pool

With this command, you delete a pool for dynamic address translations.

You are in the Interface configuration mode

The command prompt is as follows:

cli(config-if-$$)#

Call up the command with the following parameters:

no ip nat pool <inside global ip>

The parameter has the following meaning:

inside global ip

A pool is deleted.

Further notes

You configure a dynamic address translation with the

You display the current configuration with the

With this command you configure static port translations (NAPT) for an interface with a

You are in the Interface configuration mode

The command prompt is as follows:

cli(config-if-$$)#

Start address for the dynamic assign-

ment of addresses at which devices

are reachable from external.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

Enter a valid IPv4 address.

Configuration Manual, 06/2016, C79000-G8976-C252-11