Siemens SCALANCE XM-400 Configuration Manual page 351

specified interface assigned directly to it. This is followed by a change to the DHCPPOOL
configuration mode. You then configure the other settings in the DHCPPOOL
configuration mode.
3. If you call the
with the next free pool ID is created and you change directly to the corresponding
DHCPPOOL configuration mode.
You then configure the interface and the other settings in the DHCPPOOL configuration
mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip dhcp-server pool [{ <pool-id (1-24)> | [{ vlan <vlan-id (1-4094)> | <interface-
type> <interface-id> }]}]
The parameters have the following meaning:
Parameter
pool-id
vlan
vlan-id
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the
You delete the entry with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command without parameters, and IPv4 address band
ip dhcp-server pool
Description
ID of the addressed IPv4 address band
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
no ip dhcp-server pool
Network protocols
7.5 DHCP server
Range of values / note
1 ... 24
-
1 ... 4094
Specify a valid interface.
command.
exit
command.
351