No Ipv6 Nd Suppress-Ra - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.2 IPv6 protocol
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
ipv6 nd suppress-ra
Result
IPv6 router advertisement packets are not distributed.
Further notes
You enable IPv6 routing with the
You display this setting and other information with the
You enable the distribution of IPv6 router advertisement packets with the command
nd suppress-ra
7.2.4.13

no ipv6 nd suppress-ra

Description
With this command, you enable the distribution of IPv6 router advertisement packets.
Requirement
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 nd suppress-ra
330
ipv6 unicast-routing
.
command.
show ipv6 interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.
no ipv6