No Ip Igmp Last-Member-Query-Interval - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp last-member-query-interval <value(1-255) tenths of seconds>
The parameters have the following meaning:
Parameter
value
tenths of seconds
Result
The period of time is specified.
Further notes
You can reset the time to the default with the
command.
You display the setting and other information with the
command.
8.2.3.8

no ip igmp last-member-query-interval

Description
With this command, you reset the time during which the multicast router searches for further
clients after the last Leave message to the default value.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ip igmp last-member-query-interval
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Value for the time interval
Specified in tenths of seconds
no ip igmp last-member-query-interval
Layer 2 management protocols
Range of values / note
1 ... 255
Default: 10
-
show ip igmp global-config
8.2 IGMP
447