No Radius-Server - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Security and authentication

11.2 RADIUS client

secret-key-string

For information on addresses and interfaces, refer to the section "Addresses and interface

names (Page 42)".

If optional parameters are not specified when configuring, the default values apply.

Primary server

In a network, only one RADIUS server can be selected as the primary server.

If you select a RADIUS server as the primary server, this replaces the server that previously

had the role of primary server.

no radius-server

With this command, you delete a RADIUS server entry on the RADIUS client.

You are in the Global configuration mode.

The command prompt is as follows:

cli(config)#

Keyword for the key for communication

between the authenticator and the

Value for the key

Identifies the RADIUS server as prima-

The server is used only for the login

authentication.

The server is used only for the 802.1X

authentication.

The server is used for both authentica-

tion procedures.

Tests whether or not the specified

RADIUS server is available. At the

same time you can create a new

RADIUS server and run the test.

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

127 characters

Default: "default"

Default setting

Configuration Manual, 06/2016, C79000-G8976-C252-11