Map Protocol - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
The parameters have the following meaning:
Parameter
vlan
vlan-id
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you address several VLANs, you must insert a blank before and after the hyphen, for
example
Result
The VLANs have been removed from the specified interface area.
Further notes
With the
able to configure them together.
6.1.2.3

map protocol

Description
With this command, you assign a protocol to a protocol group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
map protocol
{ip | novell | netbios | appletalk | other <aa:aa>}
enet-v2 protocols-group <Group id integer(1-100)>
The parameters have the following meaning:
Parameter
ip
novell
netbios
192
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Number of the addressed VLAN
no interface range vlan 5 - 10
command, you can put several interfaces or VLANs together to be
interface range
Description
Internet Protocol v4
Novell Netware protocol
Netbios via TCP/IP
Range of values / note
-
1 ... 4094
2 ... 4094
.
Range of values / note
HEX 08:00
HEX 81:38
HEX f0:f0
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11