Layer 3 functions
9.10 PIM (IPv4)
Result
The information on the selected bootstrap router is displayed.
Further notes
You configure candidates for the bootstrap router with the
9.10.1.7
show ip pim rp-static
Description
With this command, you display the static rendezvous points of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show ip pim rp-static
Result
The static rendezvous points of the device are displayed.
Further notes
You specify the interfaces for static rendezvous points with the
command.
9.10.1.8
show ip pim thresholds
Description
With this command, you display the threshold information for PIM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
758
or
cli#
or
cli#
ip pim bsr-candidate
rp-static rp-address
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.