Distance; No Distance - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.6 RIPv2 (IPv4)

distance

With this command, you specify the administrative distance for the RIP protocol. This value

is taken into account if routing information is learned from different routing protocols.

The lowest value for the administrative distance "1" means the highest reliability of the

routing information. Routing information from a system with the value "255" is so unreliable

that it is not learnt by the neighbor routers.

You are in the RIPv2 Router configuration mode.

The command prompt is as follows:

cli(config-rip)#

Call up the command with the following parameters:

distance dist<1-255> [route-map <name(20)>]

The parameters have the following meaning:

The value for the administrative distance is set.

Further notes

You reset the administrative distance to the default with the

This command resets the administrative distance to the default (120).

The value for the administrative dis-

Keyword for a route map

Name of the route map

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Range of values / note

Default: 120

Maximum of 20 characters.

Configuration Manual, 06/2016, C79000-G8976-C252-11