Layer 3 functions
9.3 OSPFv3 (IPv6)
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf priority
Result
The priority is reset.
Further notes
You enable OSPFv3 routing with the
You configure the priority with the
You display the configuration with the
9.3.4.13
ipv6 ospf retransmit-interval
Description
With this command you specify the time after which packets whose receipt was not
confirmed are transferred again.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
612
command.
ipv6 router ospf
command.
ipv6 ospf priority
show ipv6 ospf interface
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command.