Ripng (Ipv6); The "Show" Commands; Show Ipv6 Rip - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions

9.7 RIPng (IPv6)

9.7 RIPng (IPv6)
This section describes the commands relevant for working with routing with RIPng.
RIPng (RIP next generation) is only used with IPv6 and is defined in RFC 2080. As with RIP
(IPv4), RIPng is based on the distance vector algorithm of Bellman-Ford.
In contrast to RIPv2, RIPng is activated directly on the interface (VLAN interface / router
port) and not on the entire device.
RIPng uses the UDP port 521 and RIP the UDP port 520.
9.7.1

The "show" commands

This section describes commands with which you display various settings.
9.7.1.1

show ipv6 rip

Description
This command shows the information of the RIP database.
Requirement
● Routing with RIPng is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ipv6 rip [database]
The parameter has the following meaning:
Parameter
database
Result
The information of the RIP database is displayed.
692
or
cli#
Description
The information of the RIP database is
displayed.
Range of values / note
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11