Ntp Client; Show Ntp Info; Commands In The Global Configuration Mode - Siemens SCALANCE S615 Configuration Manual

System time

4.2 NTP client

4.2 NTP client
This section describes commands relevant for configuration of the NTP client.
4.2.1

show ntp info

Description
This command shows the current settings for the Network Time Protocol (NTP).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ntp info
Result
The current NTP settings are displayed.
4.2.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
126
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command and are then in the