Vrrp Group Shutdown - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You configure a VRRP interface with the
You display the IPv4 addresses with the
9.4.4.3

vrrp group shutdown

Description
With this command, you remove all assigned IPv4 addresses from the virtual router.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> group shutdown
The parameter has the following meaning:
Parameter
vrid
Result
All IPv4 addresses of the group are removed.
Further notes
You configure a VRRP interface with the
You display the IPv4 addresses with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
interface
show vrrp interface - vrid
Description
ID of the virtual router
interface
show vrrp interface - vrid
9.4 VRRPv2 (IPv4)
command.
command.
Range of values / note
1 ... 255
command.
command.
Layer 3 functions
633