Network structures
6.1 VLAN
Syntax
Call up the command with the following parameters:
private-vlan mapping [{add | remove}] <vlan-list>
The parameters have the following meaning:
Parameter
add
remove
vlan-list
Result
The IP interface of the primary PVLAN can be reached from the selected secondary
PVLANs.
Further notes
You delete the link between secondary PVLANs and the IP interface of the primary PVLAN
with the command
You display this setting with the
parameter.
6.1.3.4
no private-vlan mapping
Description
With this command you delete the link between secondary PVLANs and the IP interface of
the primary PVLAN with the command .
Requirement
● The interface is configured as an IP interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan mapping
202
Description
Adds secondary PVLANs.
Removes secondary PVLANs.
VLAN ID of the secondary PVLAN
no private-vlan mapping
show interfaces
Range of values / note
-
-
Separate the PVLANs with commas
if you specify several PVLANs.
.
command with the
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
private-vlan mapping