No Monitor Session Destination - Siemens SCALANCE XM-400 Configuration Manual

Further notes
You delete the destination for mirroring a port with the
command.
You end and delete a session with the
You display the configuration settings with the
12.4.2.6

no monitor session destination

Description
With this command, you delete the destination for mirroring a port.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no monitor session <session-id(1-7)> destination
{interface <interface-type><interface-id>} | remote vlan <vlan-id (1-4094)>}
The parameters have the following meaning:
Parameter
session-id
interface
interface-type
interface-id
remote vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Number of the session
7 parallel sessions are possible
only with port-based mirroring and
their ports must not overlap.
Keyword for a an interface descrip-
tion
Type or speed of the interface
Module no. and port no. of the
interface
Keyword for a RSPAN session
Number of the VLAN for the
RSPAN session
no monitor session ... destination
command.
no monitor session
show monitor session
Range of values / note
1 ... 7
-
Enter a valid interface.
If you connect a BANY Agent XM-400 with a SCALANCE
XM-400 basic device as of firmware version 5.1, you can
select up to four ports of the BANY Agent XM-400 as desti-
nation ports. The BANY Agent XM-400 supports port-based
and VLAN-based mirroring.
-
1 ... 4094
Diagnostics
12.4 Port Mirroring
command.
929