No Ip Ospf Hello-Interval; Ip Ospf Message-Digest-Key - Siemens SCALANCE XM-400 Configuration Manual

9.2.4.10

no ip ospf hello-interval

Description
With this command, you delete the interval.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf hello-interval
Result
The interval is deleted.
Further notes
You configure the interval with the
You show the configuration of the OSPF interface with the
command.
9.2.4.11

ip ospf message-digest-key

Description
With this command, you specify the password and the ID for authentication with MD5.
Note
This command is available only with layer 3.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
ip ospf hello-interval
Layer 3 functions
9.2 OSPFv2 (IPv4)
command.
show ip ospf interface
559