Static Mac Filtering; Commands In The Global Configuration Mode; Mac-Address-Table Block Static Multicast - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no storm-control level
Result
The value for the storm control function is reset to the default.
Further notes
You configure the value for the storm control function with the
command.
10.2

Static MAC filtering

This section describes commands for filtering data packet on an interface.
10.2.1

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
10.2.1.1

mac-address-table block static multicast

Description
With this command, you configure a static multicast MAC address without outgoing ports.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
command to change to this mode.
configure terminal
or
end exit
Load control
10.2 Static MAC filtering
storm-control level
command and are then in the
781