Layer 3 functions
9.2 OSPFv2 (IPv4)
9.2.1.8
show ip ospf request-list
Description
This command shows the request list. This request list contains the information required for
the LSAs.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip ospf request-list
[<neighbor-id>]
[{
}]
The parameters have the following meaning:
Parameter
neighbor-id
vlan
vlan-id
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the request list is displayed for all
neighbors.
Result
The request list displayed.
518
or
cli#
vlan <vlan-id (1-4094)> |
<interface-type> <interface-id>
Description
Router ID of the neighbor
Keyword for a VLAN connection
Number of the addressed VLAN
Type of interface
Module no. and port no. of the interface
Range of values / note
Enter the router ID. The router ID
consists of 4 numbers each be-
tween 0 and 255.
-
1 ... 4094
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11