7.5.3.5
no option
Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter
option-code
Result
The specified DHCP option is deleted.
Further notes
You configure the DHCP options 12, 66 and 67 with the
You configure the DHCP options 3 and 6 with the
7.5.3.6
pool-enable
Description
With this command you specify that this IPv4 address band will be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Code of the DHCP option
Range of values / note
Enter a valid DHCP option code.
option value-string
command.
option
Network protocols
7.5 DHCP server
command.
357