Redist-Config - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.2 OSPFv2 (IPv4)

Call up the command with the following parameters:

no network <network number> area <area-id>

The parameters have the following meaning:

network number

The OSPF interface is removed.

Further notes

You create the OSPF interface and the area with the

You can display the status of this function and other information with the

redist-config

With this command, you configure the information for the route. The routes are further

distributed with this information.

This command is available only with layer 3.

You are in the OSPF Router configuration mode.

The command prompt is as follows:

cli(config-ospf)#

Network number

Range of values / note

Enter a valid network number

enter an ID.

x = 0 ... 255

0.0.0.0 = backbone area

network area

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

show ip ospf