Vrrp Vrid-Track - Siemens SCALANCE XM-400 Configuration Manual

Simatic net industrial ethernet switches command line interface (cli)

Hide thumbs Also See for SCALANCE XM-400:

Table of Contents

Layer 3 functions

9.5 VRRPv3 (IPv4 / IPv6)

The function for pings to virtual IPv4 addresses is disabled.

Further notes

You enable the ping function for virtual IPv4 addresses with the

You display the status and the configuration of the VRRP3 interfaces with the

vrrp vrid-track

With this command, you enable VRID tracking.

When enabled, all interfaces of a VRID are monitored. When the link of an interface changes

from "up" to "down", the priority of all VRRP interfaces with the same VRID is reduced to the

This command is available only with layer 3.

You are in the VRRP Router configuration mode.

The command prompt is as follows:

cli(config-vrrp-v3)#

Call the command without parameter assignment:

vrrp vrid-track

VRID tracking is enabled.

Further notes

You disable VRID tracking with the

You display configured VRID trackings with the command

with the parameter

no vrrp vrid-track

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

vrrp virtual-ping