No Area - Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
The parameters have the following meaning:
Parameter
area-id
no-summary
Result
The area of the type Stub is configured.
Further notes
You change the type of the area with the
9.2.3.8

no area

Description
With this command, you remove or change an area of the type "Stub" or "NSSA".
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[
{ stub | nssa }
]
530
Description
Area-ID
The router does not send or receive a
summary LSA
no area
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Range of values / note
specify a valid ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
--
command.
Configuration Manual, 06/2016, C79000-G8976-C252-11