Mac-Address-Table Static Unicast - Siemens SCALANCE XM-400 Configuration Manual

Load control
10.2 Static MAC filtering
Syntax
Call up the command with the following parameters:
no mac-address-table static multicast<aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter
aa:aa:aa:aa:aa:aa
vlan
vlan-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry is deleted from the forwarding database.
Further notes
With the
configured entries.
With the
10.2.1.4

mac-address-table static unicast

Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
784
vlan<vlan-id(1-4094)>
Description
MAC address of the interface
Keyword for the number of a VLAN
connection
Number of the addressed VLAN
show mac-address-table static multicast
mac-address-table static multicast
Range of values / note
-
-
1 ... 4094
command, you display the list of
command, you create an entry.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11