● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf transmit-interval <1-1800>
The parameter has the following meaning:
Parameter
-
Result
The interval is specified.
Further notes
You enable OSPFv3 routing with the
You reset the interval to the default with the
You display the configuration with the
9.3.4.16
no ipv6 ospf transmit-delay
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Interval in seconds
ipv6 router ospf
show ipv6 ospf interface
Range of values / note
1 ... 1800
Default: 1
command.
no ipv6 ospf transmit-interval
command.
Layer 3 functions
9.3 OSPFv3 (IPv6)
command.
615