Precision Time Protocol (Ptp) Support - Siemens RUGGEDCOM RSG2288 Installation Manual

RUGGEDCOM RSG2288
Installation Guide
Mode
Status
Duplex
Speed
• Display Mode Indicator LEDs – The display mode indicator LEDs indicate the current display mode for the
port status indicator LEDs (i.e. Status, Duplex or Speed).
• Mode button – The Mode button sets the display mode for the port status indicator LEDs (i.e. Status, Duplex
or Speed). It can also be used to reset the device if held for 5 seconds.
• Alarm Indicator LED – The alarm indicator LED illuminates when an alarm condition exists.
• Power Module Indicator LEDs – The power module indicator LEDs indicate the status of the power modules.
▪ Green – The power supply is supplying power
▪ Red – Power supply failure
▪ Off – No power supply is installed
• RS-232 Console Port – The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial console port, refer to
Section 2.6, "Connecting to the
Section 1.3

Precision Time Protocol (PTP) Support

The Precision Time Protocol (PTP) module adds the ability to provide time synchronization via Ethernet using
the Precision Time Protocol (PTP) and Network Time Protocol (NTP), and to synchronize with an external IRIG-B
source or GPS network.
The PTP module features BNC ports for AM OUT, TTL IN/OUT and GPS IN. It also includes an LED to indicate
when synchronization has been achieved.
NOTE
The PTP module can only be installed in slot 6. For more information, refer to
Communication
Precision Time Protocol (PTP) Support
Green (Solid)
Green (Blinking)
Off
Green
Orange
Off
Green (Solid)
Green (Blinking)
Orange (Solid)
Off
Device".
Ports.
Color/State Description
Link detected
Link activity
No link detected
Full duplex mode
Half duplex mode
No link detected
100 Mb/s
1000 Mb/s
10 Mb/s
No link detected
Chapter 3,
Chapter 1
Introduction
3