Ip Access Control List; The "Show" Commands; Show Access-Lists - Siemens SCALANCE XM-400 Configuration Manual

11.4

IP access control list

Note
IP access control lists are available only with IPv4.
Note
Refer to the information and restrictions in section "Configuration limits (Page 37)".
This section describes commands for working with IP access control lists.
11.4.1

The "show" commands

This section describes commands with which you display various settings.
11.4.1.1

show access-lists

Description
This command shows the configuration of the access control lists (Access Control List).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show access-lists [ [{ip | mac}] <access-list-number (1-128)> ]
The parameters have the following meaning:
Parameter
ip
mac
access-list-number
If you do not select any parameters from the parameter list, the configuration of all access
control lists will be displayed.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
or
cli#
Description
Selects IP-based access lists (IP ACL)
Selects MAC-based access lists (MAC
ACL)
Number of the access control list
Security and authentication
11.4 IP access control list
Range of values / note
-
-
1 ... 128
833