Commands In The Interface Configuration Mode; Mac Access-Group - Siemens SCALANCE XM-400 Configuration Manual

Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac access-list extended<short(1-128)>
The parameter has the following meaning:
Parameter
short
Result
The MAC access control list is deleted.
Further notes
You generate a MAC ACL with the
You display the configuration of the access control list with the
11.3.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
11.3.3.1

mac access-group

Description
With this command, you enable the access control of the packets of an interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
Description
Number of the access control list
mac access-list extended
interface
Security and authentication
11.3 MAC access control list
Range of values / note
1 ... 128
command.
show access-lists
command to change to this mode.
command, you return to the
exit
command, you return to the
end
command.
827